How To Install Battery Isolator For Your Car Stereo
The following article shows how to connect a battery isolator. The isolator is installed when the car needs a second battery. This will be required by cars that have bigger stereos. Since more power is needed second battery is added with the help of an isolator.
The hood is popped. New battery is placed on the second battery tray on the driver’s side of the vehicle. It is secured using 3/8 inch ratchet and socket. Using drill the battery isolator is mounted on the fender well. Then the screws and the bracket that comes with the battery isolator are self-tapped . a length of four gauge battery cable run from the positive terminal of the first battery to the terminal on the battery isolator on the right hand side. The end of each side of the wire is stripped about half inch from the end and a terminal on to each end is crimped using a terminal crimper. The positive terminal from the first battery is connected to the terminal using a 3/8 inch ratchet and socket.
The first step involves opening the hood of the car. Then place the extra battery in the place provided for it. To secure its position a 3/8 ratchet and socket is used.
In the next step with the help of drill the battery isolator is mounted to the fender. For more secure connection use the brackets and self tapping screws that comes along with the battery isolator. A 4 gauge battery cable is used to connect the two batteries. It joins the positive terminal reductil to buy of the battery to the right side of the battery isolator. In the same way we have to connect a wire from the positive terminal of the first battery to the battery isolator. This is done using a 3/8 ratchet and socket.
In the next step a 18 gauge wire’s section is run from the battery’s ignition terminal to the steering column through a grommet . A 18 gauge wire is connected to the ignition wire with the help of blue scotchlok connector and a needle nosed pliers is used to crimp it tightly.
A 18 gauge wire run from the ground terminal on the battery isolator to the ground source on the frame. a wire is bolted to the frame on the passenger side. A ring terminal is crimped on both sides of the wire using wire crimpers and it is bolted to the ground point and the battery isolator using a 3/8 inch ratchet and socket.
The negative terminal of the secondary battery is connected to the ground point on the frame using a gauge wire and is bolted on the either end to ensure connections, now the secondary battery will start charging only when the engine is on.
Thus the article helps us to learn how to connect a battery isolator.
Learn more about Autozubehoer. Visit the popular site of powernetshop.at where you can find out all about Car stereo and what it can do for you. Get a totally unique version of this article from our article submission service
Related posts:
