Most of the power supplied by batteries is direct current supply. Even in the car, the power is supplied in direct current. Hence the music and stereo players are constructed in such a way that they work in direct current. Some of these systems may be portable and can be used at home. In such cases they need to be played in alternating current since AC is used domestically. It is not possible to play a music player from a car in alternating current supply. Therefore a converter is used. There are numerous types of this converter. One such converter that we use to do this is a converter with thumb screw connections. It involves simply changing the connections between the converter and the electronic devise. How to wire an AC to DC converter is shown in this article.
Since it involves with the handling of current some preliminary precautions must be kept in mind. Few things that will be required to carry out this are wire stripper, tools for crimping and ring terminals. The following instructions are carefully carried out for safety. This involves only a few connections and some initial steps.
Alternating current is used for supplying power to appliances. AC current flows continuously from positive to negative direction and then back to positive direction. There is no fluctuation or change in direction in DC current. Some devices can run with the help of battery that is they use Direct current or DC power. The AC to DC converter has DC power terminals . From these DC power terminals remove the wiring nuts and thumb screws . This can be done by turning the converter to left direction.
The insulation is stripped for about half an inch from both the positive negative wires from the device that has to be converted to AC supply. This DC device can then be converted to the converter. The standardized colours of these wires are red for positive and black for negative wires. It is always safe to check the manual of the device to make sure of the colour of the two wires.
After the insulation of the wires is removed, ring terminals are slid to the end for each of the two wires. Then the terminals are crimped to the wire with the help of a tool that is used for crimping.
The AC to DC converter has both positive and negative terminals . To this positive and negative wires are connected respectively . It is necessary that the these connections are tight. Use wing nuts and thumb screws to make them tight.
The last step is the AC plug has to be plugged to the outlet of the wall. The DC device needs power which is provided by the AC to DC converter . So switch on the converter after making all the wiring and connections properly. Do not make an attempt to switch on the AC to DC converter till all wiring and connections are completed or else it may cause damage to the equipment. Put the protective cover on to the appliance.
This article would have been a good guide for how to wire an AC to DC converter and with just household power we can run many appliances very effectively by following the simple steps mentioned above.
Want to find out more about Car Hifi, then visit Author Name’s site on how to choose the best Car Audio for your needs.